Thermogroup 12 Volt Straight Square Ladder Heated Towel Rail W600 x H800mm

Product Description

Thermogroup 12 Volt Straight Square Ladder Heated Towel Rail

Output: 90Watts
IP Rating: IP55
Lead Length: 1.5m
Voltage: 12Volt
No of Bars: 7
Wiring Type: Concealed (hardwired)
Wiring Position: Any of the four mounting positions
Distance Between Mounting Points (Top to Bottom): 600mm
Distance Between Mounting Points (Left to Right): 570mm

View Thermogroup 12 Volt Straight Square Ladder Heated Towel Rail  Product Specs

Heated Towel Rails are an affordable luxury for every bathroom for warming and drying your towels.
The SS4412 Heated Towel Rail is a 600×800 7 bar polished stainless steel ladder rail.

The SS4412 electric towel dryer is a 12v unit, this means that it can be installed close to a wet area in the bathroom.
The rail comes supplied with a transformer which reduces the incoming voltage from 240v to 12v.
The rail will still operate at the same temperature and use the same amount of electricity as an equivalent 240v rail as the wattage is the same, however, the rail is operating at a lower voltage.

The rail has a wiring point on both the left and right-hand side of the rail and can be wired at either the top or bottom of the rail.
As it is a 12v unit and needs to be wired to a transformer the rail can only be hardwired.

The electric towel rail is designed to rapidly heat up and reach a temperature of around 45-55 degrees. The rail can be operated using an on/off switch however we recommend using a timer to allow you to set and forget and control your running costs.

Colours of the Thermogroup SS4412 12 Volt Straight Square Ladder Heated Towel Rail may vary. Images are for illustration purposes only and the colour or finish may vary from the actual product.

PLEASE NOTE: Thermogroup SS4412 12 Volt Straight Square Ladder Heated Towel Rail specifications are for information purposes only. Whilst every effort has been made to ensure the product specifications are accurate, due to continuing product development and improvement the specifications are subject to change.
Specifications can be used to rough in and fit timber supports in the wall however we recommend no holes are drilled without having the product on site or verifying the details with the manufacturer. Thermogroup cannot be held liable or responsible for errors due to updated specifications.

For product enquiries please feel free to contact us. One of our customer service team members will be in touch as soon as possible.